RAID
- PERC 6/E supports RAID levels 0, 1, 5, 6, 10, 50 and 60.
PERC 5/E supports RAID levels 0, 1, 5, 10 and 50.
Storage
Hard Drives
Up to fifteen (15) 1-inch-by-3.5-inch SAS hot-pluggable 3.0 Gbps hard drives, at speeds of 10,000 or 15,000 RPM
Up to fifteen (15) 1-inch-by-3.5-inch SATA II hot-pluggable 3.0 Gbps hard drives, at speeds of 7,200 RPM
Drive speeds and capacities
SAS Drives
15,000 RPM SAS drives available in 73GB, 146GB, 300GB, 450GB and 600GB
10,000 RPM SAS drives available in 300GB, 400GB1 and 600GB
Nearline SAS (7,200 RPM) drives available in 500GB, 750GB1 or 1TB1
SATA Drives
7,200 RPM SATA II drives available in 250GB, 500GB, 750GB1 or 1TB1
Energy efficient SATA II (5,400 RPM) drives available in 1TB1 and 2TB1
Maximum Capacity (per enclosure)
30TB using fifteen 2TB1 5,400 RPM SATA II disk drives in one enclosure
Expansion Capabilities
PERC RAID Controller enables expansion to 6 enclosures
More Details on PERC
PowerVault MD3000 and MD3000i enable expansion to 3 enclosures
Connectivity
Support for either of the following configurations:
Unified mode (single path) for daisy chaining of up to 6 enclosures per PERC 6/E controller (3 enclosures per port, single path)
Unified mode (redundant path) for daisy chaining up to 3 enclosures per PERC 6/E controller (3 enclosures connected to both ports via redundant path cabling)
Split mode with dual Enclosure Management Modules providing direct connectivity to drives 0 though 6 and a separate connectivity to drives 7 through 14
Management
Enclosure Management Modules (EMM):
1 or 2 modules
A second EMM provides redundant enclosure management capability
Back-Panel Connectors
- SAS connectors (per EMM):
1 12.0 Gbps SAS (SFF 8470) "IN" connector for connection to the host
1 12.0 Gbps SAS (SFF 8470) "OUT" connector for expansion to an additional enclosure
Serial connector (per EMM):
1 6-pin UART mini-DIN connector (for factory use only
LED Indicators
- Front panel:
1 two-color LED indicator for system status
2 single-color LED indicators for power and split mod
Hard-drive carrier:
1 single-color activity LED
1 two-color LED status indicator per drive
EMM:
3 two-color LED status indicators: one each for the two EMM SAS ports and one for the EMM status
Power supply/cooling fan module:
3 LED status indicators for power supply status, power supply/fan fault and AC status
Power
Wattage:
488 W maximum continuous; 550 W peak
Heat dissipation: 200 W
Voltage:100-240 V rated (actual 90-264 V)
Frequency: 47-63 Hz
Amperage: 7.2 A at 100 V, 3.6 A at 200 V
Available Hard Drive Power (per slot):
Supported consumption
Up to 1.3 A at +12 V; Up to 1.5 A at +5 V
Chassis
Height: 13.11 cm (5.16 inches)
Width: 44.63 cm (17.57 inches)
Depth: 48.01 cm (18.9 inches)
Weight: 35.37 kg (78 lb) (maximum configuration)
Environmental Operating Conditions
Temperature: Operating: 10° to 35°C (50° to 95°F). Storage: -40° to 65°C (-40° to 149°F)
Relative humidity:Operating: 20% to 80% (non-condensing). Storage: 5% to 95% (non-condensing)
Altitude:Operating: -16 to 3048 m (-50 to 10,000 ft). Storage: -16 to 10,600 m (-50 to 35,000 ft)
BTU per hour: 1430
Operating System
Refer to RAID Card for details on supported Operating Systems:
PERC 5/E/ PERC 6/E
MD3000
MD3000i
